£44.00 – £134.00 ex. VAT - £52.80
Two Pack Epoxy Floor Paint (Top Coat) – This epoxy floor coating is designed for application to concrete, cement and non ferrous metals. It provides excellent resistance to water, solvents, acids, alkalis and salts and gives superb adhesion to all recommended substrates. Tough finish has long lasting abrasion and impact resistance. Recommended for areas receiving heavy traffic (vehicle/trucks).
Following application of the product:
Do not park vehicles or place heavy equipment on the floor for a minimum of 48 hours
Do not get the floor wet for a minimum of 7 days as this will cause bloom (discolouration)
– Coverage: 5-7 m² per litre
– Touch Drying Time: 12-16 hrs
– Recoat: 24 hrs
– Hard Drying Time:48 hrs
– Full Cure: 7 days
Description
BULK ORDERS? CALL 01782 550733 FOR DISCOUNTS!
Technical Overview
Standard Colours |
Slate Grey, Light Grey, Brunswick Green, Ford Tractor Blue, Cornflower Blue, Red Oxide, Post Office Red, Caterpillar Yellow, JCB Yellow, Chocolate Brown, Bright Orange, Black, White.
*Other RAL and British Standard colours can be made, dependent on the quantities required.
|
Dry Film Appearance |
Sheen
|
Substrates |
Concrete and non-ferrous metals
|
Components |
2 (Resin and Hardener/Activator)
|
Curing Mechanism |
Solvent release and chemical reaction between components
|
Mixing Ratio (by Volume) |
Resin 4 parts: Hardener/Activator 1 part
|
Induction Time |
10 minutes (at 20°C)
|
Pot Life |
3 hours at 20°C (pot life is dependent on temperature and quantities mixed)
|
Spreading Rate |
5-7m2 per litre at 125μm (allow for application losses, surface irregularities etc.)
|
Touch Dry @20°C |
12-16 hours
|
Recoating Time @20°C |
24 hours
|
Hard-Drying Time |
48 hours
|
Full Cure |
7 days
|
Typical Wet-Film Thickness |
230μm per coat
|
Typical Dry-Film Thickness |
150μm per coat
|
Solids by Volume |
63% (ASTM D2697) ±3%, dependent on colour
|
VOC Information |
22% by weight (190g/kg)
|
Specific Gravity |
1.68 kg per litre (mixed product)
|
Application Temperature |
Minimum 5°C
|
Application Method |
Roller or brush
|
Thinners |
Standard Thinner
|
Flash Point |
Resin 36°C; Hardener/Activator 33°C (Closed Cup)
|
Pack Size |
5 litres (Resin 4 litres: Hardener/Activator 1 litre); 20 litres (Resin 16 litres: Hardener/Activator 4 litres)
|
Shelf Life |
12 months (when stored indoors, unopened, in the original containers at 5-30°C)
|
Two Pack Epoxy Floor Paint (Top Coat) – Product Description & Recommended Use
- Economical long-term protection in demanding conditions.
- Incredibly durable and hard-wearing with excellent resistance to water, solvents, acids, alkalis and salts.
- Excellent cross-linking with Regal 2-Pack Epoxy Floor Sealer (First Coat).
- Trouble-free application by roller or brush.
- Recommended for heavy-duty commercial and industrial areas.
- Ideal for areas that will be receiving heavy traffic such as vehicles and trucks.
Designed for application to concrete and non ferrous metals, Regal 2-Pack Epoxy Floor Paint (Top Coat) is the second coat in the Regal 2-Pack Epoxy Flooring System.
Regal 2-Pack Epoxy Floor Paint (Top Coat) is an incredibly durable and hard-wearing floor paint, making it ideal for use on areas that will be receiving heavy traffic, such as vehicles and trucks. It gives excellent protection against water, solvents, acids, alkalis and salts.
A tough finish and long-lasting abrasion and impact resistance.
Regal Paint® - Floor Paint Manufacturers
Regal Paint® manufactures hard wearing, long lasting, high-performance floor paint for a complete range of applications, both industrial and commercial. Our floor paints are ideally suited for application on warehouse floors, factory floors, commercial garages, MOT centres, showrooms, chemical plants, galleries and much more. Regal Paints are specialist manufacturers of epoxy floor paint, concrete floor paint, quick-drying paint, garage floor paint and more. Please contact us to discuss your requirements or consult our floor coatings FAQ section for more information..
Additional information
| Weight | N/A |
|---|---|
| Select Colour | Brunswick Green, Ford Tractor Blue, Cornflower Blue, Red Oxide, Post Office Red, Caterpillar Yellow, JCB Yellow, Chocolate Brown, Bright Orange, Slate Grey, Light Grey, Black, White |
| Select Size | 5 Litres, 20 Litres |
Related products
£49.50 ex. VAT - £59.40 inc. VAT
Masonry Paint - A water borne smooth sheen finish based on acrylic resin. Excellent covering power, with long lasting protection to all exterior substrates, guarding against weather damage. We are also able to make up batches of masonry paint to specific customer requirements. For information on the colours we supply for large and bespoke orders of 400 Litres or more, please contact us.
£28.50 – £65.00 ex. VAT - £34.20 inc. VAT
Agricultural Oxide - A long oil based protective metal coating, suitable for all types of interior/exterior substrates. It has excellent covering power and can be used on block work, steel sheets, asbestos sheeting as well as wood. It has a good gloss finish, gives protection against weathering and corrosion.
£25.00 – £62.00 ex. VAT - £30.00 inc. VAT
Exterior Wood Paint - Exterior Metal Paint - A long oil based decorative gloss finish designed for a wide range of substrates. Ideal for wooden windows/doors, metal fencing/garage doors or concrete walls. This has excellent covering power and provides long lasting weather protection. - Coverage: 5 - 10 m2 per litre - Touch Drying Time: 12hrs - Recoat: 24 hrs - Hard Drying Time: 48 hrs
£28.50 – £72.50 ex. VAT - £34.20 inc. VAT
Quick Dry High Build Floor Paint - A single pack quick dry floor coating which provides good durability against abrasion and impact along with with protection against solvent, salt and water damage. Very easy to apply. Suitable for heavy duty commercial and industrial areas.
£27.00 – £56.00 ex. VAT - £32.40 inc. VAT
Regal Prime & Seal is a single pack quick dry low viscosity penetrating first coat primer. It's designed to soak into the substrate, providing excellent adhesion of subsequent top coats. Using Regal Prime & Seal will reduce any risk off delamination due to poor penetration of heavy top coats. The sealer anchors the topcoats into the floor. Regal Prime & Seal dries with a flat finish and is opaque in colour. - Coverage: 5-10 m² per litre - Touch Drying Time: 2-4 hours - Recoat: 24 hours - Hard Drying Time: 24 hours
£71.00 ex. VAT - £85.20 inc. VAT
Single Garage Two Pack Garage Floor Paint Bundle - This garage floor epoxy bundle has been designed for easy application to concrete garage floors and provides sufficient first coat and top coat epoxy paint to coat a standard single garage floor with a beautiful, hard-wearing finish (see diagram for dimensions). This bundle consists of: 1 x 5 Lts Two pack Epoxy Undercoat Sealer 1 x 5 Lts Two Pack Epoxy Floor Paint Topcoat (Select Colour)
£142.00 – £146.00 ex. VAT - £170.40 inc. VAT
Double Garage Two Pack Garage Floor Paint Bundle - This epoxy floor paint bundle is designed for application to concrete garage floors and provides enough paint to coat a standard double garage floor (see diagram for dimensions). This bundle consists of: 2 x 5 Lts Two pack Epoxy Undercoat Sealer 2 x 5 Lts Two Pack Epoxy Floor Paint Topcoat (Select Colour)
£26.00 – £68.00 ex. VAT - £31.20 inc. VAT
Polyurethane Concrete Floor Paint - A single pack high build floor coating giving medium durability against abrasion and impact, with limited protection against solvent, salt and water damage. Polyurethane Concrete Floor Paint is easy to apply with a gloss or semi-gloss finish. Suitable for light commercial and industrial areas.
£28.50 – £72.50 ex. VAT - £34.20 inc. VAT
Quick Dry Garage Floor Paint - A single pack quick dry floor coating, giving good durability against abrasion and impact with protection against solvent, salt and water damage. Quick Dry Garage Floor Paint is easy to apply with a choice of finishes i.e. gloss/semi/matt. Suitable for heavy duty commercial and industrial areas.
£5.50 – £18.50 ex. VAT - £6.60 inc. VAT
SuperTough Aggregate is an iron-silicate grit. It has good shatter resistance and has a hard, sharp finish to give fantastic grip. To use SuperTough Aggregate on a previously-painted floor, apply a coat of floor paint and then liberally scatter the grit over the surface of the wet paint. Allow the floor to dry for a full 24 hours. Once dry, remove the excess SuperTough Aggregate that hasn’t stuck with a soft brush. Then the paint over the whole surface of the floor again to seal the grit in place on the floor.
£28.50 – £60.00 ex. VAT - £34.20 inc. VAT
High Build Phosphate Quick Dry Primer is a single pack priming solution suitable for most metal substrates. This metal paint is also suitable for pre-treated aluminium and galvanised steel. High Build Phosphate Quick Dry Primer gives excellent protection against corrosion. Excellent build levels and can be re-coated in most types of finish. - Coverage: 5 m² per litre - Touch Drying Time: 30 mins - 1 hr - Recoat: 12 hrs - Hard Drying Time: 24 hrs
£33.00 – £78.00 ex. VAT - £39.60 inc. VAT
Line Marking Paint - A single-pack quick dry high build floor paint which provides very good durability against abrasion and impact along with with protection against solvent, salt and water damage.
£85.00 – £125.00 ex. VAT - £102.00 inc. VAT
Two Pack Epoxy Floor Paint Bundle 5 Litres (25-50 sq meters coverage) - The two pack epoxy floor bundle is designed for heavy use commercial industrial areas or on flooring areas that require a low maintenance long lasting finish. The key advantages over a single pack product are greater resistance to impact and abrasion, also a much greater protection from chemical, acid and alkalis spills. A single pack floor paint may require annual maintenance to ensure high wear points don't erode however epoxy coat should last for a number of years. 3 x 5lts Product: 1x 5 lts TWO PACK EPOXY FLOOR SEALER (UNDERCOAT COAT) 1x 5lts TWO PACK EPOXY FLOOR PAINT (TOP COAT) 1x 5Lts Regal Clear Finish
£30.00 – £78.00 ex. VAT - £36.00 inc. VAT
One Coat High Build Steel Enamel - A tough long lasting, fast drying, semi-gloss primer finish made on a high build alkyd resin. Eliminates the need for two coats and cuts the drying time between coat, reducing labour and paint costs. This protects against corrosion and impacts. - Coverage: 5-10 m2 per litre - Touch Drying Time: 3-6 hours - Recoat: 16 hours - Hard Drying Time: 48 hours
£35.00 – £101.00 ex. VAT - £42.00 inc. VAT
Aluminium Quick Dry Enamel with a tough, quick drying finish. A metal paint made with high grade aluminium flake, rather than pigment, which is dissolved in solvent for 24 hours and diluted with urethan alkyd. Heat resistant up to 150 degrees C. Steel-grey in finish. Typically used to refurbish truck wheels. Advisable to spray. Never use a roller with this product.
Out of stock
£28.50 – £60.00 ex. VAT - £34.20 inc. VAT
Anticorrosive Quick Dry Primer is a single pack priming solution suitable for most metal substrates. Also suitable for pre-treated aluminium and galvanised steel. Anticorrosive Quick Dry Primer gives excellent protection against corrosion. Excellent build levels and can be re-coated in most types of finish. - Coverage: 5 m² per litre - Touch Drying Time: 30 mins - 1 hr - Recoat: 12 hrs - Hard Drying Time: 24 hrs