From £24.50 ex VAT - £29.40 inc VAT
Regal Prime & Seal is a single pack quick dry low viscosity penetrating first coat primer.
It’s designed to soak into the substrate, providing excellent adhesion of subsequent top coats.
Using Regal Prime & Seal will reduce any risk off delamination due to poor penetration of heavy top coats.
The sealer anchors the topcoats into the floor.
Regal Prime & Seal dries with a flat finish and is opaque in colour.
– Coverage: 5-10 m² per litre
– Touch Drying Time: 2-4 hours
– Recoat: 24 hours
– Hard Drying Time: 24 hours
Description
Technical Overview
Standard Colours |
Slate Grey, Light Grey, Brunswick Green, Ford Tractor Blue, Cornflower Blue, Red Oxide, Post Office Red, Caterpillar Yellow, JCB Yellow, Chocolate Brown, Bright Orange, Black, White.
*Other RAL and British Standard colours can be made, dependent on the quantities required.
|
Dry Film Appearance |
Matt
|
Spreading Rate |
5.5-8m2 per litre
|
Touch Dry @20°C |
15-30 minutes
|
Recoating Time @20°C |
14 hours
|
Typical Wet-Film Thickness |
120-160μm per coat
|
Typical Dry-Film Thickness |
65-90μm per coat
|
Solids by Volume |
56% (ASTM D2697) ±3%, dependent on colour
|
VOC Information |
430g per litre
|
Application Temperature |
10-35°C
|
Application Method |
Brush or roller
|
Substrates |
Suitably cleaned and dry surfaces
|
Thinners |
Xylene
|
Flash Point |
≥25°C
|
Pack Size |
5 litre can; 20 litre can; 205 litre barrel
|
Shelf Life |
12 months
|
Regal Prime and Seal – Product Description & Recommended Use
- A quick-air-drying, penetrating primer-coat which gives a matt finish.
- Made with high-quality alkyd resins and is lead and chrome-free.
- Excellent penetration into concrete and non-ferrous metal substrates.
- Designed to soak into the substrate, providing excellent adhesion of subsequent top coats.
- Will reduce the risk of delamination, due to poor penetration of top-coats, by anchoring the top-coat to the floor.
- Easy to apply by roller or brush.
- The ideal base for Regal Single-Pack Floor Paints to give a superior quality finish to your floor.
- Recommended for medium-duty commercial and industrial areas.
Regal Paints® - Floor Paint Manufacturers
Regal Paints® manufacture hard wearing, long lasting, high-performance floor paint for a complete range of applications, both industrial and commercial. Our floor paints are ideally suited for application on warehouse floors, factory floors, commercial garages, MOT centres, showrooms, chemical plants, galleries and much more. Regal Paints are specialist manufacturers of epoxy floor paint, concrete floor paint, quick-drying paint, garage floor paint and more. Please contact us to discuss your floor paint requirements or consult our floor coatings FAQ section for more information..
Additional information
| Weight | N/A |
|---|---|
| Select Size | 5 Litres, 20 Litres |
Related products
£27.00 ex VAT
Painting Essentials Sundries Pack - ideal for applying both single pack garage floor paint and two-pack epoxy floor paint. 3 x 4" brushes 1 x 15" roller frame 2 x 15" roller heads
From £31.50 ex VAT - £37.80 inc VAT
Regal Clear Finish is a high solids, medium viscosity, Fast physical drying coating. Displaying Very good adhesion , Very good abrasion resistance., Very good alkali and humidity resistance and Excellent hardness.It's tough, hard wearing Acrylic copolymer is blended with a xylene based solvent.
From £23.50 ex VAT - £28.20 inc VAT
Polyurethane Concrete Floor Paint - A single pack high build floor coating giving medium durability against abrasion and impact, with limited protection against solvent, salt and water damage. Polyurethane Concrete Floor Paint is easy to apply with a gloss or semi-gloss finish. Suitable for light commercial and industrial areas.
From £4.50 ex VAT - £5.40 inc VAT
Pumice aggregate is an extremely light aggregate which has the advantage of being able to mix into the paint prior to application. It is a non-microbead solution to a fine, aggregated finish. Pumice gives a rough-profiled finish and significantly increase slip resistance. When using, pour the pumice into the paint and mix thoroughly. After mixing, use the paint immediately. The paint must be applied with a roller to achieve a consistent finish.
£17.50 ex VAT
Clean n Etch 5L - This product is made for very smooth / power floated floors or dirty floors. Clean N Etch is a highly concentrated blend of non-fuming acidic compounds and cleaning agents, specifically developed to prepare concrete floors prior to applying paints and other protective coatings.
From £25.50 ex VAT - £30.60 inc VAT
High Build Phosphate Quick Dry Primer is a single pack priming solution suitable for most metal substrates. This metal paint is also suitable for pre-treated aluminium and galvanised steel. High Build Phosphate Quick Dry Primer gives excellent protection against corrosion. Excellent build levels and can be re-coated in most types of finish. - Coverage: 5 m² per litre - Touch Drying Time: 30 mins - 1 hr - Recoat: 12 hrs - Hard Drying Time: 24 hrs
From £25.50 ex VAT - £30.60 inc VAT
Quick Dry Garage Floor Paint - A single pack quick dry floor coating, giving good durability against abrasion and impact with protection against solvent, salt and water damage. Quick Dry Garage Floor Paint is easy to apply with a choice of finishes i.e. gloss/semi/matt. Suitable for heavy duty commercial and industrial areas.
From £39.50 ex VAT - £47.40 inc VAT
Two Pack High Build Epoxy Garage Floor Paint - Designed for application to concrete, cement and non ferrous metals. Excellent resistance to water, solvents, acids, alkalis and salts. Gives superb adhesion to all recommended substrates. Tough finish has long lasting abrasion and impact resistance. Recommended for areas receiving heavy traffic (vehicle/trucks). - Coverage: 5-7 m² per litre - Touch Drying Time: 12-16 hrs - Recoat: 24 hrs - Hard Drying Time: 48 hrs - Full Cure: 7 days
From £33.50 ex VAT - £40.20 inc VAT
Two-Pack Epoxy Floor Sealer (Under Coat) - This epoxy floor paint (first coat) is designed to prepare the surface of concrete, cement and non ferrous metals. This gives an ideal base for epoxy topcoat or acts as a seal coat for bare concrete floors. Resistant to water, solvents, acids, alkalis and salts. Tough finish, and has long lasting abrasion and impact resistance. Recommended for areas receiving heavy traffic (vehicle/trucks). Following application of the product: Do not park vehicles or place heavy equipment on the floor for a minimum of 48 hours Do not get the floor wet for a minimum of 7 days as this will cause bloom (discolouration) - Coverage: 5-7 m² per litre - Touch Drying Time: 12-16 hrs - Recoat: 24 hrs - Hard Drying Time: 48 hrs - Full Cure: 7 days
From £39.50 ex VAT - £47.40 inc VAT
Two Pack Epoxy Floor Paint (Top Coat) - This epoxy floor coating is designed for application to concrete, cement and non ferrous metals. It provides excellent resistance to water, solvents, acids, alkalis and salts and gives superb adhesion to all recommended substrates. Tough finish has long lasting abrasion and impact resistance. Recommended for areas receiving heavy traffic (vehicle/trucks). Following application of the product: Do not park vehicles or place heavy equipment on the floor for a minimum of 48 hours Do not get the floor wet for a minimum of 7 days as this will cause bloom (discolouration) - Coverage: 5-7 m² per litre - Touch Drying Time: 12-16 hrs - Recoat: 24 hrs - Hard Drying Time:48 hrs - Full Cure: 7 days
From £71.00 ex VAT - £85.20 inc VAT
Single Garage Two Pack Garage Floor Paint Bundle - This garage floor epoxy bundle has been designed for easy application to concrete garage floors and provides sufficient first coat and top coat epoxy paint to coat a standard single garage floor with a beautiful, hard-wearing finish (see diagram for dimensions). This bundle consists of: 1 x 5 Lts Two pack Epoxy Undercoat Sealer 1 x 5 Lts Two Pack Epoxy Floor Paint Topcoat (Select Colour)
From £22.50 ex VAT - £27.00 inc VAT
Anticorrosive Quick Dry Primer is a single pack priming solution suitable for most metal substrates. Also suitable for pre-treated aluminium and galvanised steel. Anticorrosive Quick Dry Primer gives excellent protection against corrosion. Excellent build levels and can be re-coated in most types of finish. - Coverage: 5 m² per litre - Touch Drying Time: 30 mins - 1 hr - Recoat: 12 hrs - Hard Drying Time: 24 hrs
From £29.50 ex VAT - £35.40 inc VAT
Line Marking Paint - A single-pack quick dry high build floor paint which provides very good durability against abrasion and impact along with with protection against solvent, salt and water damage.
From £142.00 ex VAT - £170.40 inc VAT
Double Garage Two Pack Garage Floor Paint Bundle - This epoxy floor paint bundle is designed for application to concrete garage floors and provides enough paint to coat a standard double garage floor (see diagram for dimensions). This bundle consists of: 2 x 5 Lts Two pack Epoxy Undercoat Sealer 2 x 5 Lts Two Pack Epoxy Floor Paint Topcoat (Select Colour)
From £25.50 ex VAT - £30.60 inc VAT
Quick Dry High Build Floor Paint - A single pack quick dry floor coating which provides good durability against abrasion and impact along with with protection against solvent, salt and water damage. Very easy to apply. Suitable for heavy duty commercial and industrial areas.
From £5.50 ex VAT - £6.60 inc VAT
SuperTough Aggregate is an iron-silicate grit. It has good shatter resistance and has a hard, sharp finish to give fantastic grip. To use SuperTough Aggregate on a previously-painted floor, apply a coat of floor paint and then liberally scatter the grit over the surface of the wet paint. Allow the floor to dry for a full 24 hours. Once dry, remove the excess SuperTough Aggregate that hasn’t stuck with a soft brush. Then the paint over the whole surface of the floor again to seal the grit in place on the floor.